450 372-0812tech@ressortsfoster.comFrançais

Spring rate calculator

Get the rate, load and stress of a compression, extension or torsion spring from the wire diameter, the outside diameter and the number of coils.

Spring type
Units

Spring rate

–

Load
–
Spring index
–
Mean diameter
–
Stress
–

    The result is an estimate. Foster checks the design before making the spring.

    Method

    How the calculator works

    The calculator uses the standard formulas for round-wire helical springs and typical values for each material. The result is an estimate: confirm the design with Foster before you order.

    Compression spring rate

    k = G d⁴ / (8 D³ Na)

    G is the shear modulus of the wire, and d is the wire diameter. D is the mean diameter (the outside diameter minus the wire diameter), and Na is the number of active coils. The stress includes the Wahl factor, which adds the higher stress on the inside of the coil.

    Extension spring rate

    Na = Nb + G / E

    The rate uses the same formula, with the body coils plus G / E for the hooks. The load adds the initial tension that holds the coils closed. The calculator doesn’t check the stress in the hooks.

    Torsion spring calculator

    k = E d⁴ / (10.8 D Na) per turn

    E is the modulus of elasticity. Each leg adds L / (3πD) coils. The constant 10.8 allows for friction between the coils. The body winds tighter as it turns, so keep the arbor smaller than the loaded inside diameter.

    The stress bar compares the stress at your travel with the usual static limit for the material. The limit is a share of the wire’s minimum tensile strength: 45% for music wire in compression, and less for stainless steel and bronze. Above the limit, the spring can take a set (stay shorter after the load comes off).

    Questions

    Common questions

    What is spring rate?

    Spring rate, also called the spring constant, is the force that compresses or stretches a spring by one unit of length, in N/mm or lbf/in. A spring with a rate of 10 lbf/in needs 25 lbf to compress 2.5 in.

    How do you calculate the spring constant of a coil spring?

    Use k = G d⁴ / (8 D³ Na). The wire diameter has the most effect: twice the wire diameter makes the spring 16 times stiffer, and twice the coil diameter makes the spring 8 times softer. The load is then the rate times the deflection.

    How is the rate of a torsion spring calculated?

    Use k = E d⁴ / (10.8 D Na) for the torque per turn, then divide by 360 for the torque per degree. Each leg adds L / (3πD) active coils.

    What spring index should I aim for?

    The spring index is the mean diameter divided by the wire diameter. Between 4 and 12, a spring is easy to coil and stays consistent. Under 4, the wire is hard to coil. Over 12, the springs can tangle.

    Can Foster make the spring I calculated?

    Send the result with the request form: the calculator fills in the values for you. Foster makes compression, extension and torsion springs to order in Granby, Quebec, from a prototype to production runs.

    A spring to replace or a part to develop?

    Send your drawing or a photo, or call us at 450 372-0812.

    Request a quote